REPLACEMENT ORIFICE FOR X-JET NOZZLE

REPLACEMENT ORIFICE FOR X-JET NOZZLEX Jet Nozzles contain an internal orifice which is gauged (sized) to match your GPM PSI. Many times, we get calls from customers ordering a replacement orifice due to loss or wear and tear that will occur over time from water pressure. We also receive calls requesting a different size internal orifice size to use with a different GPM PSI machine. Remove the internal spring and orifice from the nozzle and then replace with the new orifice. Remember to

1/4 FPT  (inlet) x 1/4 MPT (outlet)

Valve Assembly

15 mm pumps

UD-14 BRASS RETAINER "P" SERIES 20MM

Case design has “breakout” sections at the rear and side for lead wire exit and a hood to neatly cover and protect these wires where required

Built for speed

quiet operation and fit standard engines with a 3/4" keyed shaft

Agitate bad oils stains/bad areas if needed

The VHP50 Unloader by AR Pumps is rated:

Temperature of handle 3" from bottom w/175 F

compare to Hypro D252

Painted steel 3" motor shell