End Cap for Cross Member

End Cap for Cross MemberLots of bumper on the market reuse the factor lower support nuts that come in a square block. With these caps youll be able to eliminate those and be supplied with proper grade 8 hardware and these rubber end caps. Whats included: 2 black end caps 1. 5 grade 8, 5 8 hex bolts with 4 washers and 2 lock nuts (Optional) This kit isnt specific to any bumper but works with most bumper on the market. If you have questions, email us at support@tacovinyl. com

they do not come pre-installed

Protective Shipping: Each garnish comes with a protective film to ensure it arrives at your door 100% scratch-free

Please refer to our Tech Installation Guide for proper antenna placement

This reduces shock load and wear and tear on the inner and outer tie-rods

Please add Route Protection at checkout

This is the no-hassle Toyota radio mount you need

Two Iconic Palettes: * Classic: Brighter

we recommend gluing the actual mounting clips into the grille standoffs during installation

Finish: Satin Black ABS

3M Adhesive: Pre-applied internal 3M adhesive ensures your overlays stay locked in place for the long haul

Using its patented ball joint design

This can make a critical difference in clearance while off-roading