Amana Tool 46100 Solid Carbide Spiral Plunge 1/8 Dia x 1/2 x 1/4 Inch Shank Up-Cut

Amana Tool 46100 Solid Carbide Spiral Plunge 1/8 Dia x 1/2 x 1/4 Inch Shank Up-CutSpiral flute bits combine a shearing action in cutting with an augering action in chip clearance. The shearing action yields an especially clean accurate cut while the augering action clears chips from the cut. The Up Cut shears from the bottom up pulling chips from the bottom up thus allowing deeper penetration with less stress on the tool. An excellent choice for mortising. Special unique carbide grade increased clearance geometry and razor sharp

and add an elegant detail simultaneously with these bits

1/4" diameter for closer inside corner cutting only

The assembly order for each setup is shown in the drawing

Do you want even more

Designed for the "smart clip" backsplash system

table and counter edges

This bit produces a fingernail flute

Form keyhole slots in plaques

Improved chip clearance is possible with a single flute configuration

If a smaller pilot bearing is used

Must be used with an edge guide on handheld routers or the fence on a router table

small trim and small decorative moldings