SparkFun FTDI Cable 5V Arduino, Other

SparkFun FTDI Cable 5V Arduino, OtherThe FTDI cable is a USB to Serial (TTL level) converter which allows for a simple way to connect TTL interface devices to USB. The I O pins of this FTDI cable are configured to operate at 5V. The FTDI cable is designed around an FT232RQ, which is housed in a USB A connector. The other side of the cable is terminated with a 0. 1" pitch, 6 pin connector with the following pinout: RTS, RX, TX, 5V, CTS, GND (RTS is the green cable and GND is black). This

This a simple breakout board for the button pads

The cleaning cloth features special saw tooth pattern edges

The cable’s connector is composed of two rows of five 0

All moving parts are protected within the housing

5�C over wide temperature range (0 to +50�C for both Ta and To)

Low power consumption: the power of xenon metal halide lamp for vehicle is only around half of tungsten halogen lamp but emitting 3 time of light Quick start: 25% of objective luminous flux can be reached within 1second

0mm OD) that you may need to increase the hole diameter on some perf boards

distance and stability

The hardware interface is sixteen (two rows of eight) through-hole pins

Material: Nylon Shape: Ring

The FTDI Basic uses DTR to cause a hardware reset where the FTDI cable uses the RTS signal

but the fully packaged antennas have better strain relief where the SMA cable meets the antenna housing