QU40300U Used D60 Diff OP Shaft

QU40300U Used D60 Diff OP ShaftQU40300U Used Dodge Dana 60 Differential Output or Intermediate Shaft for all 1994 1999 Dodge Ram 2500 4x4 trucks with 8800 lb. or higher GVW. QU40300U Differential Output or Intermediate Shaft also fits on all 1994 1999 Dodge Ram 3500 4x4 trucks. This shaft is the innermost shaft on the right (passenger) side. It is installed through the right axle tube and pushed all the way in until the splines on the inboard end are fully engaged with the

Included Gaskets

QT2028 GM 4x4 Output Shaft Nut Socket removes/installs the mainshaft nut on all GM 4500's with or without a vibration dampener

After Installing:

Always use a new Cross Shaft Retaining Pin to hold the cross shaft in place

in fact more universal joints and axle yokes are wrecked by slam-bang methods of u-joint replacement than by any other cause

and Dana 70 closed knuckle front axles fits both lower and upper positions with bearings

Cup & Cone

however you also get some RTV sealant you will need to clean off the mating surfaces

QU50152 Range Slider Shift Hub with 2-way Input Side Clutch Teeth for many New Process NP231 and NP241 series Transfer Cases

J-Series Truck: 1967

5 Dodge Ram Front CV Driveshaft

QU10954 Left (short side) Axle Shaft Assembly