SparkFun RF Link Receiver - 4800bps (434MHz) General

SparkFun RF Link Receiver - 4800bps (434MHz) GeneralThese wireless receivers work with our 434MHz transmitters. They can easily fit into a breadboard and work well with microcontrollers to create a very simple wireless data link. Since these are only receivers, they will only work communicating data one way, you would need two pairs (of different frequencies) to act as a transmitter receiver pair. Note: These modules are indiscriminate and will receive a fair amount of noise. Both the transmitter and

5 inputs (buttons)

but the parts are still the same so the video should still be helpful

20 x Training flags

As the sensor is flexed

1" headers and likewise with output on the right-hand side

Our Arduino Pro boards and LilyPads use this type of connector

or any activity where you want to get a "lower than the helmet

This sensor does not have a load resistor built in

Digital-output temperature sensor

Key Specifications:

Knobs are a great way to finish off your project and make it easier to adjust the level of your death ray

This breakout board makes it easy to prototype using this tiny device by breaking out the necessary pins to a standard 0