CMFH154010

CMFH154010Manufactured with a 24ga 304 Stainless Steel Lid, 3 4 inch 18ga Stainless Steel Mesh available in 5 different heights(8 inch,10 inch,12 inch,14 inch & 16 inch) & a 1. 5 inch wide Stainless Steel Swing Hinge.

Liner Mesh sock opens up to slide over the insulation then use the Liner Mesh Clamps to hold the insulation tightly to the pipe

Tee snouts are standard female end to accept male connections

We do not reccomend rotating elbow gores more than 15 degrees as it weakens the seams

Manufactured with stainless steel by ICP for use with square or rectangular masonry chimneys

ALUMINUM SEAL W/ 500DEG SILICONE

The Saf-T Wrap Tee Section Wrap installs around the tee top and down to about half the height of the snout

to Small Female BL Rods / Tools

in 33 degree temperatures or higher

and are manufactured with Titanium Stainless Steel Tee Liner Kits (316) include: SmoothWall Stainless Steel Liner (316) TPCC - Square Lid Cap to fit the Flat Top Plate with Collar (24ga 304) TPC - Flat Top Plate with Collar 13x13 (24ga 304) TB - Tee Body (24ga 316) TS - 10 inch Long Tee Snout (24ga 316) TEC - Tee End Cap (24ga 316) Installation Instructions & Warranty Card

fits outside tile dimensions 11

5 inch diameters

This sealant resists peak temperatures of around 1100 degrees F but is designed for use with a continuous operating temperature of around 900 degrees F