Adafruit DS2484 I2C to 1-Wire Bus Adapter Breakout

Adafruit DS2484 I2C to 1-Wire Bus Adapter BreakoutBy customer request, this is a DS2484 Stemma QT board that uses a I2C to 1W controller chip, with ESD protection and support for split supplies. You can easily connect it to an existing I2C bus and then use the screw terminals to attach multiple DS18B20's, or pair it with our 1 Wire chaining breakouts for fancier experimentation. You're probably familiar with the 'top three' electronics protocols: I2C, SPI and UART. Perhaps you're aware of a fourth

and it provides multiple function thanks to its unique modular design and rich interfaces

The thick copper layer means it can carry a lot of current

serial logging

socket for NVMe SSD

or you can program it yourself as you would an Arduino or similar microcontroller

Onboard ATtiny 13A microcontroller for power management functionality

If call detected parser will hang up call

EdBuild – EdRoboClaw

Primary Guide: Adafruit VCNL4040 Proximity Sensor

breakbeams are faster and allow better control of where you want to detect the motion

3V 5V 10 5V Power Supply Ground GND 8 GND GND 9 GND Ground ONBOARD SETTINGS AND INDICATORS

we recommend you buy the version of Win10 Enterprise Activated