Differential Bushings

Differential BushingsThe factory differential mounts originally equipped in the RX 8 are made from natural rubber. As the years and miles add up the rubber dries out and the mounts become soft which allows the differential to move excessively and ultimately limiting performance. These high performance mounts are designed to eliminate the issue and provide consistent launches from a standstill as well as putting power to the road coming off the corner! Made from authentic

In mild conditions the factory radiator originally equipped in the RX-8 can provide adequate engine cooling with the addition of our cooling fan control kit

Our new unit is a direct bolt in replacement for the OE plastic unit and is compatible with completely stock (as shown) or with modified vehicles as well

The Syncro-Saver when installed properly will eliminate the additional excessive travel of the shifter with a definitive shifter stop which in turn will eliminate the binding of components inside the transmission

fresh air is drawn in from the front of the vehicle which could be 80-120 degrees colder depending on the ambient air temperature

This is a very high quality custom fit Sunshield and its a practical

Improved low rpm throttle response and torque due to higher engine compression

To have this service performed simply purchase it through our website

Aftermarket Cabin Air Filter

O2 Oxygen Sensor for Front

We also included a magnetic drain plug allowing the owner or technician to inspect the oil for debris and internal engine wear during routine oil changes

See manifold pic

Dowel Pin O-Rings