Navico Speed Sensor with Transom Mount Paddle Wheel

Navico Speed Sensor with Transom Mount Paddle WheelThis Speed Sensor is a transom mounted paddlewheel that uses the flow of water beneath the boat to measure speed. The Speed Sensor can be teamed up with a Fuel Flow Sensor to monitor the vessels fuel economy. o Cable Length: 18" (46cm) from connector to smart module. 10 ft (3 m) from module to end of cable o Mounting location: Transom. Hole required to route through a bulkhead: 7 8" (22mm) o Supplied with N2K T RD Micro C T connector (000 0119 79)

Harmonic distortion typical: < 5 % Cos phi: all power factors allowed Transfer system: the Masterswitch and Systemswitch can be connected to all sine wave inverters Temperature range (ambient temp

8mm pins (5/16) for up to 3

open coil spring

fishing in depths of less than 3000ft

Monohull Dinghy

manual Technical specifications Protection degree: IP21

and a elastomer enclosed corrugated boot

BRAVO 6 can be transformed in a single

TCD 2042 Control panel - For operating the BTQ bow-thruster through a joystick

Multiple Networking Connections - Compatible with NMEA 2000

A 30 metre (98ft) VHF mast cable for 1720 antenna

5W o IP security degree: 40 o Light colour: Daylight-Red