Linear Shaft - 440 Stainless Steel - NIM20SS-0300-SL Diameter: 20mm Length: 300mm

Linear Shaft - 440 Stainless Steel - NIM20SS-0300-SL Diameter: 20mm Length: 300mmLinear Shaft of 440 Stainless Steel, 20mm diameter, 300mm length, made in the USA by PBC Linear, featuring RC 50 Plus hardness and an optimized surface finish that enhances the performance of linear bearings such as self lubricating plain bearings and ball bearings. Solid, not pre drilled. Neither drilled nor tapped pre drilled shafts are NIPDM (metric) or NIPDL (inch) Order custom lengths, tapping and hole spacing via "Configure and Quote" below

helping compensate for minor angular misalignment between parallel shafts without forcing the shaft and liner into a rigid bind

Pre-drilled according to industry standard hole spacing

and contaminants will not stick

6" length and 4 adjustable Frelon®J self-lubricating plugs on each of 4 sides

of 510 mm rail length with a low-profile 23mm height design for tight spaces

This assembly comes as a two-piece set with a separate shaft and support rail

with a 2" compensated ID that provides a 0

Can operate in any orientation

Bored Aluminum Housing - Self-lubricating ID liner FrelonGOLD®

ISO Metric Series - Open

Crafted from anodized aluminum for lightweight strength

Plain Linear Bearing with a square flange and a 3/8" precision ID